VCI-100 Touch Sensors Response
VCI-100 Touch Sensors Response Posted on: 16.05.2010 by Karena Katherine So I recently just purchased the new overlay and had applied it put it back together and now the Jog Wheel Touch Sensor seems to get stuck or whatever you might call it after just touching both Jog Wheels just once. At one point after spinning the jog wheels for a couple of times it would go back to normal but now it will stay in the touch position (red color) instead of turning back to blue. Any suggestions would be great! | |
| Karena Katherine 16.05.2010 | So I recently just purchased the new overlay and had applied it put it back together and now the Jog Wheel Touch Sensor seems to get stuck or whatever you might call it after just touching both Jog Wheels just once. At one point after spinning the jog wheels for a couple of times it would go back to normal but now it will stay in the touch position (red color) instead of turning back to blue. Any suggestions would be great! |
| Leeanna Ayla 20.07.2010 | There's two sensitivity adjusters on the back, one for each jog wheel. |
| Matha Eaden 20.07.2010 | wait this just happened to me too but it was only on the right wheel. how should i do it for just one because wouldnt the sensitivity affect both? I had to get the left wheel fixed so they may have put the other wheel on wrong |
| Karena Katherine 16.05.2010 | Wow! that is exactly what it needed..the one thing I did not do, what a bummer haven't been able to use it for a month...ha well thanks for the post this was very helpful! |
| Corine Kasman 16.05.2010 | I had the same thing a couple of weeks ago. Just make sure you put the jogs back on properly and then lower the sensitivity on the back of the unit. Use a SMALL screwdriver and be VERY careful in turning the little pots (someone broke one the other week...). A little adjustment is probably all it needs. Let us know if this helped. Phil. |
<< Back to DJ TechTools' VCI-100 FAQReply