Dicers: Release message getting ignored by Traktor?
Home :: Post and find Controller Mappings :: Dicers: Release message getting ignored by Traktor?Reply
Dicers: Release message getting ignored by Traktor? Posted on: 06.08.2011 by Latrice Atcherson Hi!I've been redoing the DJTT Dicer v1.0 mapping in TSP2 (for learning purposes). Everything was going fine, until I tried to recreate the Beatmasher effect/layout from the MidiFighter IG mapping. Basically, in the green mode, it would be required to hold down the button 1, 2 & 3 for button 4/5 to work. Now, the problem is, Traktor seems to be ignoring the release message sent from the Dicer. It does register it because if I "learn" and press/hold 1 & 2, the "learn" box changes from 2's value to 1's value (just released). Anyone else had this problem, or found a way to work around it? Thanks! | |
| Latrice Atcherson 06.08.2011 | Hi! I've been redoing the DJTT Dicer v1.0 mapping in TSP2 (for learning purposes). Everything was going fine, until I tried to recreate the Beatmasher effect/layout from the MidiFighter IG mapping. Basically, in the green mode, it would be required to hold down the button 1, 2 & 3 for button 4/5 to work. Now, the problem is, Traktor seems to be ignoring the release message sent from the Dicer. It does register it because if I "learn" and press/hold 1 & 2, the "learn" box changes from 2's value to 1's value (just released). Anyone else had this problem, or found a way to work around it? Thanks! |
<< Back to Post and find Controller MappingsReply