use KP3 for Traktors effects! (.tsi inside)
use KP3 for Traktors effects! (.tsi inside) Posted on: 13.10.2009 by Sherika Lasee the X-Y touch pad acts just as it does for the KP3's internal effects,slide up or down for the one parameter across for the other, or diagonally for a Z axis to adjust both parameters at once & quickly find that sweet spot. To use your Kp3 as a controller in any software you first need to Install the Kp3 Editor software, Connect the usb, Then Hold the [SHIFT] button then press [8] (this will switch the unit to external control mode) Next save the .tsi file iv attached below, open Traktors' midi set up, hit Import, then pick to open my .tsi any ideas for a more smooth map state freely goodtimes over n' out - stephen | |
| Sherika Lasee 13.10.2009 | the X-Y touch pad acts just as it does for the KP3's internal effects, slide up or down for the one parameter across for the other, or diagonally for a Z axis to adjust both parameters at once & quickly find that sweet spot. To use your Kp3 as a controller in any software you first need to Install the Kp3 Editor software, Connect the usb, Then Hold the [SHIFT] button then press [8] (this will switch the unit to external control mode) Next save the .tsi file iv attached below, open Traktors' midi set up, hit Import, then pick to open my .tsi any ideas for a more smooth map state freely goodtimes over n' out - stephen |
| Terra Merigold 18.06.2012 | sweet! |
| Donnell Francia 18.06.2012 | Thank you very much! |
| Dorcas Bassignani 23.06.2010 | is that all the buttons that can be mapped? or did you not need them all? |
<< Back to Post and find Controller MappingsReply