S4 with DJTT Knobs and Faders
S4 with DJTT Knobs and Faders Posted on: 31.01.2011 by Charline Dye The VCI knob pack arrived today. The faders needed a little help fitting, but weren't too much trouble.I put them where I did to go with a 12inch skin i'm going to put on. | |
| Carlee Pickard 31.01.2011 | Nicely done, personally though i'd definitely stick with my stock S4 stuff, it looks perfect the way it is! |
| Stefania Robusto 31.01.2011 | Glad you posted this, S4 comes tomorrow and I've got a pack of knobs here waiting for it. I'm going to mark my gains and filters so I can see them easier. Did you have to switch the inserts for anything? |
| Leeanna Ayla 31.01.2011 | I was believeing about doing the same, but I really like the nice rubbery feel of the S4 knobs. |
| Jerome Burruss 31.01.2011 | Looks very nice! |
| Charline Dye 31.01.2011 | To get the knobs off I had to use a small flat screw driver with a post card underneath (to keep from scratching the S4) to gently lift the knob. Not hard at all. To make the faders fit I heated a small flat screw driver that was the same size as the fader's metal tang, and pushed it into the new knob to make it fit better. This worked perfectly on the line faders, but the cross fader must have a longer metal piece, because it wouldn't sit quite as far down as the others. |
| Dewey Melchi 31.01.2011 | Just out of curiousity, how much was "not too much trouble" on the faders? as well as the whole process, Im down for some sick green onces as well, just afraid i'll break the thing as I've never done it. |
<< Back to NI - Native Instruments S4/S2 Controller talkReply