Is it possible to turn off the phono preamps of a Ecler Nuo 2.0 mixer?
Home :: Reviews of DJ equipment :: Is it possible to turn off the phono preamps of a Ecler Nuo 2.0 mixer?Reply
Is it possible to turn off the phono preamps of a Ecler Nuo 2.0 mixer? Posted on: 15.02.2012 by Kiyoko Wellisch I can't find any information on it at all and there's no immediately obvious way of doing so. I'm not overly optimistic that there is a method but I thought I would ask here just in case someone has any info. | |
| Kiyoko Wellisch 15.02.2012 | I can't find any information on it at all and there's no immediately obvious way of doing so. I'm not overly optimistic that there is a method but I thought I would ask here just in case someone has any info. |
| Trinity Gradin 20.02.2012 | it's perfectly acceptable. you're wrong. |
| DJ MENSAH 20.02.2012 | Not if you care for the sound quality. |
| Trinity Gradin 19.02.2012 | what you want is an inverse RIAA convertor. I bought a couple a while ago for the exact same reason. |
| DJ MENSAH 19.02.2012 | You could open it up and remove/replace some components. Worked for me on numark mixer. All it took is replacing a resistor and a capacitor. I basically disconnected the RIAA preamp and connected the RCAs to where the output of RIAA preamp was with the same components that line-in line has. |
| Pauletta Place 14.02.2012 | Ok, I don't believe it is possible. You could attenuate the incoming signal. Or run it through a phono DI box. |
| Kiyoko Wellisch 14.02.2012 | I'm trying to get additional line inputs. |
| Pauletta Place 14.02.2012 | Can't you just use the line in? |
<< Back to Reviews of DJ equipment Reply