Reply to X1 Mixer Mapping 1.0

Here is my X1 Mixer mapping. A lot of the controls act the same way as they do in the standard mapping from NI.
To use my mapping, set your X1 to MIDI mode and load up the TSI. You can switch between Mixer Mode and FX mode, but when you change modes, soft takeover doesn't work, and your volume levels will jump.

Baiscally there are two modes in the mixer map. Mode 1 has volume knobs, high eq, mid eq and low eq set as the knobs at the top. Mode 2 uses the FX1/ON/> button in the top left as a modifier to set the knobs as Volume, Filter, high EQ, Low EQ. in Mode 2 the FX2/ON/> button is the toggle for "Filter On" on both A and B.

I've drawn a map which I hope to post here.

Ideas, feedback, requests, suggestions etc, all welcome.

(I've attached a picture in the next post)

Jimmy

X1_mixer_map_1_0.jpg

X1_mixer_map_1_1.tsi