too ambitious? or best idea ever?
too ambitious? or best idea ever? Posted on: 21.02.2011 by Yong Aptekar I have a BCD3000 and I love MOST of it. My biggest complaints are the buttons and knobs are way too close together, the jogwheel is too small and too close to my pitch faders, and the buttons are too small. My plan is to open the controller up, remove the pcb, buttons, faders etc. And mount them all into a larger case. I work at RIM, so I have quite a few friends with solder experience, but I'm wondering if anyone else has tried something like this. I don't have the extra $$ to just buy a larger controller so I want to mod my bcd. | |
| Yong Aptekar 21.02.2011 | I have a BCD3000 and I love MOST of it. My biggest complaints are the buttons and knobs are way too close together, the jogwheel is too small and too close to my pitch faders, and the buttons are too small. My plan is to open the controller up, remove the pcb, buttons, faders etc. And mount them all into a larger case. I work at RIM, so I have quite a few friends with solder experience, but I'm wondering if anyone else has tried something like this. I don't have the extra $$ to just buy a larger controller so I want to mod my bcd. |
| Franklin Momany 21.02.2011 | Bump on the photos. It appears the main board is one solid piece and I don't have a clue what options are available. So unless you have the ability to pry and or cut off the faders, jogs and buttons. Maybe possible. Usually buttons are a series of "metal" that is embeded on the board. In that case you would have to DIY, making a bypass. Soldering the connections to a aftermarket button. Faders are usually a unit that has pins going into th board. You could shave and cut them out and just connect them with wire. Imo Sounds a bit over ambitious, but I do believe its possible. Just not worth the effort and the possibility of damage is something to take into consideration. |
| Tania Somppi 21.02.2011 | I believe it's v.similar to the 2000 inside http://www.youtube.com/watch?v=kqQaSbsQVqY If it is, then it's gonna be a lot of work to remove the parts from the 2 main boards with a rework station and a mile of desolder braid to then add extension wires and space everything out a bit more. Cutting the boards into sections and rejoining the tracks with extension wires is another possibility that would require less work/tools and skill, if the board isn't too complicated on the underside. It would probably make it easier to mount everything in a new case easier as well, as you could drill some new screw holes in the boards to attach them to a new case. I'd just swap it for a RMX or save up for something better tbqh. |
| Yong Aptekar 21.02.2011 | I'm at work right now, I will take pics when I get a chance, my only concern is that the buttons/faders etc are soldered to the pcb, and not mounted to the case. If they are soldered, it will be more work, but soldering wires to the leads on the buttons and then to the pcb won't be an issue. Any suggestions for enclosure suppliers that have a case the size of a vms4? |
| Teresia Janusch 21.02.2011 | in theory you could remove the pcb, install it into a larger case, and use something like cat 5 cable to extend each pot |
| Arcelia Siebeneck 21.02.2011 | open it up and take some photos of the circuit boards... someone on here will be able to give you a better answer. I'd say you'd probably need to speak to your friend to see if he has the skills/inclination to do the solder work for you! |
<< Back to Reviews of DJ equipment Reply