VCI-100 frm1.3 (my midi mapping problem)

I have a vci-100 updated to frm 1.3 with your Kit.
I'm using TPro 1.1.2
I have my own mapping and my problem is this...
I have mapped the FX section of the vci to be exactly as in the GUI of Tpro.
The Problem is that when Switching from Advanced mode to Chained it seems that Traktor is still receiving the midi commands for both modes and sends out midi commands i don't want (LED indication specifically)
Button leds where going off without any reason...
To understand better imagine this...
IN CHAINED mode i have mapped the buttons (SW34,SW35,SW36) of each three fx to be on/off [toggle] with LED Output, but sometimes when depressing the on/off of the first fx (SW34) which in ADVANCED mode is RESET (so in ADVANCED mode it should turn off the leds on SW35,SW36), the LEDS of the other two (SW35,SW36) go off although it should n't, yet in Traktor the buttons remain ON and lighted.

The Mapping is:
In CHAINED mode
SW34-> -toggle- on/off for FX1 with LED output (when ON lighted,when off not lighted)
SW35-> -toggle- on/off for FX2 with LED output (when ON lighted,when off not lighted)
SW36-> -toggle- on/off for FX3 with LED output (when ON lighted,when off not lighted)
In ADAVANCED mode
SW34-> -trigger- Effect Parameter RESET no output
SW35-> -toggle- Effect Button 1 with LED output
SW36-> -toggle- Effect Button 2 with LED output


Why does that happen? I believe it has to do with Traktor. When it receives the Note E6 from SW34 it toggles the FX1 in chained to on/off but also resets the advanced mode fx and sends out command for the lights to go off as it should if it was in advanced mode

And another thing i've been experiencing in all the frm version i had for VCI (1.1,1.2,1.3) is that sometimes the LEDS are not lighted up (example the cue buttons do not always follow the softaware)
Why is that?