tsi mapping problem - assignement table empty
tsi mapping problem - assignement table empty Posted on: 01.04.2010 by Ayana Shvartsman hi everybodyfirst of all, sorry for my bad english, i'm from belgium. i have a problem with 3.4 and 3.5 tsi mapping. i have imported the tsi file several times but when i choose vestax vci100se in the device setup, the assignment table is empty and so the vestax control nothing. can you tell me if it s because i have a vci100 1.2 and not a vci100se ? because, when my controller is not connected, i can can see the assignment table of my personnal tsi when i choose generic midi as device setup... i would like to buy the firmware kit and flash my vestax into a vci100SE but i don't know if that will solve my problem because when nothing is connected and after importing the new 3.5 tsi, i can't see the assignment table , but with my old tsi, i can see the assignment table full of commands when i select the generic midi as device setup??? thx very much for helping me | |
| Ayana Shvartsman 01.04.2010 | hi everybody first of all, sorry for my bad english, i'm from belgium. i have a problem with 3.4 and 3.5 tsi mapping. i have imported the tsi file several times but when i choose vestax vci100se in the device setup, the assignment table is empty and so the vestax control nothing. can you tell me if it s because i have a vci100 1.2 and not a vci100se ? because, when my controller is not connected, i can can see the assignment table of my personnal tsi when i choose generic midi as device setup... i would like to buy the firmware kit and flash my vestax into a vci100SE but i don't know if that will solve my problem because when nothing is connected and after importing the new 3.5 tsi, i can't see the assignment table , but with my old tsi, i can see the assignment table full of commands when i select the generic midi as device setup??? thx very much for helping me |
| Ayana Shvartsman 02.04.2010 | thx very much, i had updated traktor but the shortcut on my desktop was still the shortcut of the 1.21 version. Thx a lot |
| Andera Meidl 01.04.2010 | I had this problem when I was using an version of Traktor lower than 1.24, make sure you have at least 1.24 (1.25 is the current version) |
<< Back to DJ TechTools' VCI-100 FAQReply