Cant Flash VCI100
Cant Flash VCI100 Posted on: 03.04.2011 by Cyril Morrone HelloLike many others, I cant get my VCI to flash - boot error. Unit is going into boot mode, I've looked all over the community and cant find an answer I bought the whole kit and cable from DJTT plus knobs and overlay - bit of a waste of cash if I cant get the thing to flash What do I do now?? Will DJTT send a free replacement chip or something else? It's battered my brain all day today Very disappointed Gary | |
| Keeley Gobble 04.04.2011 |
Originally Posted by geeebeee
If not: Take a Ducktaperoll and place the VCI on top of it so that surely no button is pushed nor one jogwheel touched/moved. Then try again. That was the problem when I tried to flash my VCI. |
| Cyril Morrone 03.04.2011 | Hello Like many others, I cant get my VCI to flash - boot error. Unit is going into boot mode, I've looked all over the community and cant find an answer I bought the whole kit and cable from DJTT plus knobs and overlay - bit of a waste of cash if I cant get the thing to flash What do I do now?? Will DJTT send a free replacement chip or something else? It's battered my brain all day today Very disappointed Gary |
| Cyril Morrone 05.04.2011 | Thanks for the suggestions guys - these are all things i'd gleaned from the other threads on the subject. I've tried them but still no further forward - really do appreciate the feedback I've logged a call with DJTT - i'll know by the end of the week if it's the chip/lead/pc or whatever; the Serial>USB cable will allow me to try a couple of laptops too to see where we go next. Gary |
| Ulysses Satterfield 05.04.2011 | Are you sure that the serial cable is properly plugged into the firmware chip? Had a similar issue flashing mine over the weekend, and it was because I hadn't pushed the serial connector down far enough. |
| Cyril Morrone 04.04.2011 | Thanks for the suggestions guys but still no luck. Ive ordered a serial to usb cheap cablr on the offchance there is a problem with the connection Gary |
| Leeanna Ayla 04.04.2011 | Or hold it on it's side. |
| Keeley Gobble 04.04.2011 |
Originally Posted by geeebeee
If not: Take a Ducktaperoll and place the VCI on top of it so that surely no button is pushed nor one jogwheel touched/moved. Then try again. That was the problem when I tried to flash my VCI. |
<< Back to DJ TechTools' VCI-100 FAQReply