Misbehaving Crossfader
Misbehaving Crossfader Posted on: 17.11.2011 by Rosaria Reneman So currently I am using a VCI-100 SE. It was 1.4 firmware but was downgraded to 1.3. The problem I am having with the crossfader is that every time I push it all the way to the left or right, it will start "twitching" from the middle and back in the software. To illustrateThe Crossfader could be set like so (The plus sign is the actual fader knob) |-+------| But on the software (and in turn, the sound) it is show as being here, as well as jumping between the two: |----+---| I am not sure where to even begin with this problem. Could it be software? Perhaps hardware? | |
| Rosaria Reneman 17.11.2011 | So currently I am using a VCI-100 SE. It was 1.4 firmware but was downgraded to 1.3. The problem I am having with the crossfader is that every time I push it all the way to the left or right, it will start "twitching" from the middle and back in the software. To illustrate The Crossfader could be set like so (The plus sign is the actual fader knob) |-+------| But on the software (and in turn, the sound) it is show as being here, as well as jumping between the two: |----+---| I am not sure where to even begin with this problem. Could it be software? Perhaps hardware? |
| Leeanna Ayla 17.11.2011 | You need to clean it. Go ahead and do the channel faders while you're in there. http://www.djranking s.com/2010/08/1...ers-jog-wheel/ |
<< Back to DJ TechTools' VCI-100 FAQReply