Moving Loops

Moving Loops Posted on: 20.11.2011 by Adam Hindall Hello Is there a way to move a loop 4 or 8 bars to the left or right on a track? I know we can adjust the length of the loops, but I would like control where a loop is on the track. Thanks Danny
Adam Hindall 20.11.2011	Hello Is there a way to move a loop 4 or 8 bars to the left or right on a track? I know we can adjust the length of the loops, but I would like control where a loop is on the track. Thanks Danny
Samual Ogura 21.11.2011	Yes. You're going to need to map the following commands either to (most likely a pair of) buttons, or an encoder: Cue/Loops>Cue/Loop Move Mode- Button, Direct to Loop Cue/Loops>Cue/Loop Move Size- Button, Direct to whatever # of beats (or loop, for the size of the active loop) Cue/Loops>Cue/Loop Move- either [button inc/dec] or [encoder relative]
Leeanna Ayla 21.11.2011	Well since the question is in the VCI-100 community I believe he's probably using a VCI-100. What mapping are you using?
Deeann Cheron 20.11.2011	edit: didnt realise the section, Dj sb had the answer below.

Copyright 2012-2023 DJRANKINGS.ORG n.g.o. Chuo-ku, Osaka, Japan	Created by Ajaxel CMS
Terms & Privacy