Problem with my xone 1D
Problem with my xone 1D Posted on: 05.06.2010 by Maximo Stuckart Can anyone could hook me up with your mapping? I'm having some issues with it. The top 4 rotary knobs to be exact. I have them mapped to load the set loop, and control the link length. It's mapped fine, but when I try to turn the knob to change the loop length, it goes nuts!! It jumps from 4 to 16 back to 2 and 32, etc... It's not consistent at all. Any suggestions would really help! Thanks! | |
| Maximo Stuckart 05.06.2010 | Can anyone could hook me up with your mapping? I'm having some issues with it. The top 4 rotary knobs to be exact. I have them mapped to load the set loop, and control the link length. It's mapped fine, but when I try to turn the knob to change the loop length, it goes nuts!! It jumps from 4 to 16 back to 2 and 32, etc... It's not consistent at all. Any suggestions would really help! Thanks! |
| gabriel ortiz 06.06.2010 | Yul beat me to it. I had this issue with my MPK49 on Traktor 3. I had the wrong type of control selected for a knob and when I selected rotary all was well. |
| Kecia Wnukowski 06.06.2010 | as a guess only: you may not have set up your 1d correctly, you have two ways of setting the unit so the top encoders react either as endless encoders or as 'buttons' (left and right) which is the setting you wanna have. Please read your manual it's explained at the very beginning. |
| Random X 06.06.2010 | BitterSugar, if you have problems with your controller/mapping, please use this community
. However, I am believeing you have a problem with a defunct. 1Ds are known to have some problems with haywire MIDImessages. |
<< Back to Post and find Controller MappingsReply