VCI-100 LED Question.
VCI-100 LED Question. Posted on: 15.06.2010 by Dave Lapka Hey guys,Sorry, I've just bought a VCI so I'm probably gonna have a few questions over the next couple of days. The community here has always been very good to me so I'll hope you'll bare with me! So, todays problem: Without going too much into it, I've mapped 'SET CUE' button below the jog wheel as a 'toggle' button. However, the LED will only turn green while the button is pressed.. ie the LED is acting like a 'hold' button when I want it to act like a 'toggle' button. Is there anyway of changing this as I can't seem to find away and it's really gonna screw up the mapping I've been planning for this machine. Thanks guys, any help as always is greatly appreciated. | |
| Dave Lapka 15.06.2010 | Hey guys, Sorry, I've just bought a VCI so I'm probably gonna have a few questions over the next couple of days. The community here has always been very good to me so I'll hope you'll bare with me! So, todays problem: Without going too much into it, I've mapped 'SET CUE' button below the jog wheel as a 'toggle' button. However, the LED will only turn green while the button is pressed.. ie the LED is acting like a 'hold' button when I want it to act like a 'toggle' button. Is there anyway of changing this as I can't seem to find away and it's really gonna screw up the mapping I've been planning for this machine. Thanks guys, any help as always is greatly appreciated. |
| Leeanna Ayla 15.06.2010 | Have you seen this? http://www.djranking s.com/2010/05/3...ds-in-traktor/ |
<< Back to Post and find Controller MappingsReply