Turning off LEDs for Cue in VCI-100 SE
Turning off LEDs for Cue in VCI-100 SE Posted on: 20.08.2010 by Jessika Kienast The default in the standard VCI-100 mapping included with Traktor Pro / Scratch Pro has the LED for the two Cue buttons as that green and it turns blue when activated. Is it possible to have it off when inactive and blue when activated? I plan to leave it as the Cue button.Also, I plan to use the two Key buttons to switch the deck transport controls and EQ between A / B and C / D so they'll basically function as Shift buttons with one set as Modifier #3 and the other Modifier #4. Problem is when I use them to load tracks, it loads to both Decks A and C or B and D at the same time. My last question is whether it's possible to have it work in a latching fashion as in I press the one on the left deck to get it to switch controls to Deck C but the one on the right is independant and still controls Deck B until I press Key to switch it over to Deck D. | |
| Jessika Kienast 20.08.2010 | The default in the standard VCI-100 mapping included with Traktor Pro / Scratch Pro has the LED for the two Cue buttons as that green and it turns blue when activated. Is it possible to have it off when inactive and blue when activated? I plan to leave it as the Cue button. Also, I plan to use the two Key buttons to switch the deck transport controls and EQ between A / B and C / D so they'll basically function as Shift buttons with one set as Modifier #3 and the other Modifier #4. Problem is when I use them to load tracks, it loads to both Decks A and C or B and D at the same time. My last question is whether it's possible to have it work in a latching fashion as in I press the one on the left deck to get it to switch controls to Deck C but the one on the right is independant and still controls Deck B until I press Key to switch it over to Deck D. |
| Leeanna Ayla 21.08.2010 | I've done some more digging and I'm not sure this is possible because traktor tells the VCI the cue is off and that tells the VCI to turn the light on. You can switch which color is on by checking invert next to controller range in the controller manager, but i'm sure you know that already. What about borrowing the cue function from the DJTT mappings and swapping the two buttons above the two current cue buttons for cue? Then your effect buttons would have two colored lights. Not sure which you would prefer. Anybody else have any ideas? |
<< Back to Post and find Controller MappingsReply