VCI-100 / Traktor issue
VCI-100 / Traktor issue Posted on: 26.02.2011 by Luann Scillieri Im running traktor 1.2.4 and for some reason, its not picking up any of the input signals from the VCI, it was working fine for months, not sure what changed. For some reason I'm believeing that the VCI is on MIDI channel 2 instead of 1, i saw that if you hold one of the small buttons near the top left it sets it to channel 2, but how do you reset it back to channel 1? i tried holding down button 2 while powering it on, didnt seem to do anything.should i get 3rd party software to try and change the midi channel? i know on mac theres audio MIDI setup or something along those lines in the control panel, cant seem to find anything like this in vista. any help would be great! | |
| Luann Scillieri 26.02.2011 | Im running traktor 1.2.4 and for some reason, its not picking up any of the input signals from the VCI, it was working fine for months, not sure what changed. For some reason I'm believeing that the VCI is on MIDI channel 2 instead of 1, i saw that if you hold one of the small buttons near the top left it sets it to channel 2, but how do you reset it back to channel 1? i tried holding down button 2 while powering it on, didnt seem to do anything. should i get 3rd party software to try and change the midi channel? i know on mac theres audio MIDI setup or something along those lines in the control panel, cant seem to find anything like this in vista. any help would be great! |
| Luann Scillieri 26.02.2011 | what should the IN bet set to and what should OUT be set to? IN : VCI, Out: audio interface? i seem to remember before both options were set to all ports |
| Leeanna Ayla 26.02.2011 | Are you sure the in/out ports for the VCI mapping are set in the controller manager. 1.2.7 is the latest version of traktor with some pretty big bug fixes in it. I would recommend opening the Service Center and upgrading. |
<< Back to Post and find Controller MappingsReply