Mapping play and pause
Mapping play and pause Posted on: 12.03.2011 by Jannette Nikocevic Hi, im kinda new in this things, and im needing some help,there it goes:ive assigned play for one button, and i want to use it in 2 decks(not at the same time), is it possible to assign othe key to change de deck, and then play it? like Ean uses shift.. pardon my english and my noobness.. thanks | |
| Alexandra Nerby 13.03.2011 |
Originally Posted by fullenglishpint
|
| Alexandra Nerby 13.03.2011 |
Originally Posted by inquilinofodido
|
| Jannette Nikocevic 12.03.2011 | Hi, im kinda new in this things, and im needing some help,there it goes: ive assigned play for one button, and i want to use it in 2 decks(not at the same time), is it possible to assign othe key to change de deck, and then play it? like Ean uses shift.. pardon my english and my noobness.. thanks |
| Tatum Ansaldo 13.03.2011 | is that a question? or a problem? |
| Jannette Nikocevic 13.03.2011 | i havent separated the play pause for deck a and b |
| Alexandra Nerby 13.03.2011 |
Originally Posted by fullenglishpint
|
| Tatum Ansaldo 13.03.2011 | I assume it was because you hadn't set m1 as one of the conditions on the play/pause? |
| Alexandra Nerby 13.03.2011 |
Originally Posted by inquilinofodido
|
| Jannette Nikocevic 12.03.2011 | Solved.. thanks for the pacience. best regards |
| Jannette Nikocevic 12.03.2011 | ive done that and then this. play/pause deck a and b respectively still not working...am i missing something? |
| Alexandra Nerby 12.03.2011 | Create 1 modifier, but with two options... So select modifier 1, make it a button, and under that select hold. M1 and value 1, assignment - global, and finally at the bottom, button options - button value is 0 Repeat: Second modifier but still select modifier 1, button, hold, m1 and value 0, global, button value 1. That should do it! |
| Jannette Nikocevic 12.03.2011 | i tried that...but im doing something wrong.. ive created m#1 and in the mapping details i used play/pause deck a in and value 0 in one of the modifiers and deck b in the other with value 1. the mistake must be after that.. |
| Alexandra Nerby 12.03.2011 | Yes of course. There are probably a few ways to do this, but the first that comes to my mind is to create a modifier. That will be the button that you press to select either deck A or B. When this button = 0 the play button would play deck A When this button = 1 the play button would play deck B I'm not in front of Traktor right now, so I forget what the parameters are called, but that's the jist of it. It's a little bit of trial and error when mapping. |
<< Back to Post and find Controller MappingsReply