APC40 Mapping Issue
APC40 Mapping Issue Posted on: 15.05.2011 by Dana Ordinario I just picked up an APC 40 and I love it. I have been hard at work creating a custom mapping for it but I have hit a snag and can't seem to get these buttons to work correctly. Whatever I map to the Pan, Send A, Send B, Send C buttons always works correctly but never turns off correctly. Currently I have Filter On mapped to the Pan Button located below Knob 5. When I press this button the light turns on and so does the filter. When I hit the button again nothing happens. When I hit it a 3rd time it turns off but the light comes back on. I'm not too worried about the LEDs being wrong atm I can fix that later but I am concerned that whatever I keep mapping to these button never turn off unless I press them twice. Anyone have any idea what may be causing this? On another note I have been trying to find a way to map a layout change button to not only change the decks and mixer layout but also to switch from having 2 FX units to 4 and vice versa any help on that would be awesome. | |
| Dana Ordinario 15.05.2011 | I just picked up an APC 40 and I love it. I have been hard at work creating a custom mapping for it but I have hit a snag and can't seem to get these buttons to work correctly. Whatever I map to the Pan, Send A, Send B, Send C buttons always works correctly but never turns off correctly. Currently I have Filter On mapped to the Pan Button located below Knob 5. When I press this button the light turns on and so does the filter. When I hit the button again nothing happens. When I hit it a 3rd time it turns off but the light comes back on. I'm not too worried about the LEDs being wrong atm I can fix that later but I am concerned that whatever I keep mapping to these button never turn off unless I press them twice. Anyone have any idea what may be causing this? On another note I have been trying to find a way to map a layout change button to not only change the decks and mixer layout but also to switch from having 2 FX units to 4 and vice versa any help on that would be awesome. |
| Dana Ordinario 16.05.2011 | TY Padi worked like a charm. I didn't understand what you were talking about until I mapped it but for anyone else who runs into this problem the fix is those buttons are hardwired to be "toggle" switches so when you set them to Hold even thou you release the button the controller is still sending the signal that it is pressed. Making it act as if you had set it to toggle instead of hold. Thanks again Padi |
| Dana Ordinario 16.05.2011 | Hmmm I had the controller in dumb mode and was still getting an issue Ill have to retry it and see what I can do thanks Padi |
| Nedra Fresneda 16.05.2011 | Those are indeed hardwired as toggles, so map them as hold in Traktor to avoid double presses. This changes if you use the controller in dumb mode (all buttons act as hold). |
| Dana Ordinario 16.05.2011 | Reading over that post I fixed the LED problem with a simple send monitor state which I assumed was the issue. It doesn't fix the bigger problem thou. Whenever I press any of those 12 buttons I can get it to light up and turn whatever effect I want on then it takes TWO press of that button to turn it off. That with having a modifier set to directly change the state from 0 - 1 and 1 - 0. It has to be something hardwired into the APC I'm going to go post on the Akai message boards see if I can't get an answer from them. |
| Demetra Pinizzotto 16.05.2011 | Scroll to post 7 thats the solution that works for me |
<< Back to Post and find Controller MappingsReply