Add IN , Add OUT ????
Add IN , Add OUT ???? Posted on: 16.05.2011 by Heike Mumm I dont understand these 2 features. I simply use Add IN to select the commands i want mapped. However, what does ADD OUT do ??? | |
| Heike Mumm 16.05.2011 | I dont understand these 2 features. I simply use Add IN to select the commands i want mapped. However, what does ADD OUT do ??? |
| Heike Mumm 17.05.2011 | Thanks! I'll approach this later i guess. I've only just delved into traktor and mapping my controls. |
| Loreta Makemson 16.05.2011 | I had trouble with this too when I was mapping my leds to blink with the beat. So I look it at like this... Add in is to put in information ex.such as this X button does this X function Add out is to send out information ex. This X button will blink (sending out) according to the beat of the song. Hope it helps. |
| Venetta Cawyer 16.05.2011 | Add In = adding an input. Add Out = adding an output. That should be simple enough for ya. If not, you shouldn't be looking at it anyhow. |
| Heike Mumm 16.05.2011 | Thanks, still a bit but thanks, will try and figure it out...... |
| Branda Limani 16.05.2011 | Add out is for making an led light up. |
<< Back to Post and find Controller MappingsReply