apc40 activate,solo,arm as effect unit on?
apc40 activate,solo,arm as effect unit on? Posted on: 23.05.2011 by Eddie Maina hmmm... it doesn't toggle correctly. any ideas?current behavior: no led= effect off push button to activate unit = led is on = effect is on push button to turn off unit = led off = effect unit on push button again = led on = effect unit off push button again = led off = effect unit off uh? shouldn't it simply be off = unit off and on= unit on? | |
| Eddie Maina 23.05.2011 | hmmm... it doesn't toggle correctly. any ideas? current behavior: no led= effect off push button to activate unit = led is on = effect is on push button to turn off unit = led off = effect unit on push button again = led on = effect unit off push button again = led off = effect unit off uh? shouldn't it simply be off = unit off and on= unit on? |
| Dana Ordinario 24.05.2011 | I had this same issue. The problem is that those buttons are hard wired as toggle buttons. So even when you set it to hold it acts like a toggle because of the way the APC is hardwired. |
| Demetra Pinizzotto 24.05.2011 | You have the APC in dumb mode? (open up ableton to get the red box around the clips. Then close ableton (all lights go out on your apc40), thats dumb mode. Then the hardware toggle buttons dont mess up your mapping in traktor. I have my apc's mapped for dumb mode, works like a charm! |
| Eddie Maina 24.05.2011 | so yeah... it has to be set to hold instead of toggle... any ideas why? |
<< Back to Post and find Controller MappingsReply