My Maschine Maps itself..help?

Home :: Post and find Controller Mappings :: My Maschine Maps itself..help?Reply
My Maschine Maps itself..help?
Posted on: 28.09.2011 by Viviana Nevers
Hey Everyone,

Need a little help with mapping my Maschine to Traktor. I know how to map my functions just fine. But when I assign, let's say ( a hot cue to a pad) it will also loop even though I never assigned loop at all. Some functions just seem to map automatically. Even on others maps. This has been very frustrating. Please, some help. Thank-J
Viviana Nevers
28.09.2011
Hey Everyone,

Need a little help with mapping my Maschine to Traktor. I know how to map my functions just fine. But when I assign, let's say ( a hot cue to a pad) it will also loop even though I never assigned loop at all. Some functions just seem to map automatically. Even on others maps. This has been very frustrating. Please, some help. Thank-J
Nedra Fresneda
28.09.2011
Does this only happen with Mashcine?
Have you checked that you don't have any other mapping file loaded that might be conflicting with the new one? If so then disable the In/Out ports on the older one or if it's a different controller then check their I/O aren't set to listen to all controllers but the specific one you are targeting with that map.

<< Back to Post and find Controller MappingsReply

Copyright 2012-2023
DJRANKINGS.ORG n.g.o.
Chuo-ku, Osaka, Japan

Created by Ajaxel CMS

Terms & Privacy