Controller interference
Controller interference Posted on: 02.12.2011 by Lakeshia Dampf I bought a numark mixtrack pro about 5 months ago and i have been using that with traktor until i got a NI kontrol x1 and a novation launchpad for free. I was planing to use the x1 with traktor along with the mixtrack pro and the launchpad with ableton live that would be synced up with traktor. The only problem is that when i run ableton with the launchpad and the mixtrack with traktor on the same computer is that the launchpad keep interferring and controlling traktor. The launchpad is not listed in traktor's controller menu and i don't know how to turn it of. Does anyone know how to make the launchpad stop controlling traktor? it woud be awesome if somebody could help me. | |
| Cliff Lohman 05.12.2011 |
Originally Posted by McBadderson
For example, I have 2 or 3 controllers on channel 3 all working OK. However, I did see an issue once where I plugged something in and got some conflicts but it was on an OUT command. Any articles, etc that help with this topic? I found traktor bibles chapter on it a good piece of info but Im still a little confused about why things should be on seperate channels.. is it mostly for the OUT commands? And I suppose its also useful when u want to set IN/OUT ports to ALL, right? |
| Lakeshia Dampf 02.12.2011 | I bought a numark mixtrack pro about 5 months ago and i have been using that with traktor until i got a NI kontrol x1 and a novation launchpad for free. I was planing to use the x1 with traktor along with the mixtrack pro and the launchpad with ableton live that would be synced up with traktor. The only problem is that when i run ableton with the launchpad and the mixtrack with traktor on the same computer is that the launchpad keep interferring and controlling traktor. The launchpad is not listed in traktor's controller menu and i don't know how to turn it of. Does anyone know how to make the launchpad stop controlling traktor? it woud be awesome if somebody could help me. |
| Cliff Lohman 05.12.2011 |
Originally Posted by McBadderson
For example, I have 2 or 3 controllers on channel 3 all working OK. However, I did see an issue once where I plugged something in and got some conflicts but it was on an OUT command. Any articles, etc that help with this topic? I found traktor bibles chapter on it a good piece of info but Im still a little confused about why things should be on seperate channels.. is it mostly for the OUT commands? And I suppose its also useful when u want to set IN/OUT ports to ALL, right? |
| Ivan Guting 05.12.2011 | Sounds like they are on the same MIDI channel sending conflicting MIDI messages. |
<< Back to Post and find Controller MappingsReply