dn-mc6000 help
dn-mc6000 help Posted on: 29.03.2012 by Edward Shindelar just got my unit in the other day. loaded up traktor pro (1.2.7) and it seems like its acting a little buggy. volume faders do not work, cross fader does not work, levels dont seem to be responding correctly, and when i load 4 tracks only track A will play any sound. (only playing 1 track but both are lit and the LEDs dont seem to be working correctly. used traktor pro's pre-made mapping for it and ive also tried traktor bible's (very last one on the page) most of the buttons and knobs are working (jog wheel, eq's, efx, cues) i feel like getting traktor pro 2 would solve all my problems but if possible i rather stick to 1 because 2 just seems over whelming and i rather just stick to the basics of traktor right now. i feel like the firmware on denon's website is for t2. if its possible, if anyone out there is using a dn-mc6000 with traktor 1.2.7 and has a working map and wouldnt mind passing it to me? or if i could get some support from you guys. thanks in advance ! | |
| Edward Shindelar 29.03.2012 | just got my unit in the other day. loaded up traktor pro (1.2.7) and it seems like its acting a little buggy. volume faders do not work, cross fader does not work, levels dont seem to be responding correctly, and when i load 4 tracks only track A will play any sound. (only playing 1 track but both are lit and the LEDs dont seem to be working correctly. used traktor pro's pre-made mapping for it and ive also tried traktor bible's (very last one on the page) most of the buttons and knobs are working (jog wheel, eq's, efx, cues) i feel like getting traktor pro 2 would solve all my problems but if possible i rather stick to 1 because 2 just seems over whelming and i rather just stick to the basics of traktor right now. i feel like the firmware on denon's website is for t2. if its possible, if anyone out there is using a dn-mc6000 with traktor 1.2.7 and has a working map and wouldnt mind passing it to me? or if i could get some support from you guys. thanks in advance ! |
| Edward Shindelar 01.04.2012 | yeah it was set to int mixer. need it set to PC mix if i want to use 4 decks |
| Celina Crusey 30.03.2012 | Well, you didn't answer my question. Are you mixing externally or using traktors internal mixer? What is the switch on the back of the unit set to? Then check traktors "mixer" preferences and make sure it corresponds correctly to the unit. I'm pretty sure with the external mixer you can only mix two decks. |
| Edward Shindelar 30.03.2012 | oh wow im retarded, thanks kritical. now i found that i cant use all 4 decks to play. a&b have sound and everythings good but c&d arent producing any sound. I can control decks c&d but i cant get any sound from them or at least show any dB levels. any suggestions? just trying to get EVERYTHING to work so i wont run into any problems later on, thanks |
| Celina Crusey 30.03.2012 | Look at the back of the unit...is the switch for mixing set to PC mix or External Mix? |
<< Back to Post and find Controller MappingsReply