APC20 LED Mapping
APC20 LED Mapping Posted on: 08.10.2012 by Amina Rusko hi i tried to map my APC20 but the led feedbacks are not like number i wrote.for example i mapped the "set loop" to led red when its off and when its on i should be green. but the led gives me only one color green or in invert red. some one know what can i do? tnx | |
| Kayce Mesia 08.10.2012 |
Originally Posted by djnamnam
If you have an APC40, you have to start up Ableton with the APC40 as a control surface. When Ableton recognizes the APC40 and uses it as a control surface, the APC40 goes into "Ableton" mode. Closing Ableton will make the APC40 go into "dumb" mode. |
| Amina Rusko 08.10.2012 | hi i tried to map my APC20 but the led feedbacks are not like number i wrote. for example i mapped the "set loop" to led red when its off and when its on i should be green. but the led gives me only one color green or in invert red. some one know what can i do? tnx |
| Amina Rusko 09.10.2012 | can your APC20 work without power supply? |
| Kayce Mesia 08.10.2012 |
Originally Posted by djnamnam
If you have an APC40, you have to start up Ableton with the APC40 as a control surface. When Ableton recognizes the APC40 and uses it as a control surface, the APC40 goes into "Ableton" mode. Closing Ableton will make the APC40 go into "dumb" mode. |
| Kellie Myrum 08.10.2012 | I found this. It was originally posted by photojojo: Midi value 0=on 1, 7-127=green 2=green blinking 3=red 4=red blinking 5=amber 6=amber blinking To change the way the LED's on the knobs act. 0=off, 1=Single, 2=Volume Style, 3=Pan Style, 4-127=Single And thread: http://community .djranking s.com/showthread.php?t=49387 |
| Amina Rusko 08.10.2012 | what is that 'dumb' mode? didn't traktor 2.5 fixed it? |
| Kellie Myrum 08.10.2012 | If I remember correctly your APC need to be in "dumb" mode. |
<< Back to Post and find Controller MappingsReply