apc40 traktor cue points
apc40 traktor cue points Posted on: 10.04.2013 by Johnie Abbas I've been trying to do custom mapping of my apc40 with traktors cue points but am running into trouble. I want to make it so that if their is a cue point set, the led is green and remains green, and if there is no cue points set yet, it is orange. As of right now with the following setting, if there is no cue points set yet, it is orange. But once the cue point is set, the color disappears.current settings. select/set+store hot cue ch.02.note.f#3 button hold deck A hot cue 2 Hot Cue 2 type deck A min max 0 0 midi range 5 1 | |
| Johnie Abbas 10.04.2013 | I've been trying to do custom mapping of my apc40 with traktors cue points but am running into trouble. I want to make it so that if their is a cue point set, the led is green and remains green, and if there is no cue points set yet, it is orange. As of right now with the following setting, if there is no cue points set yet, it is orange. But once the cue point is set, the color disappears. current settings. select/set+store hot cue ch.02.note.f#3 button hold deck A hot cue 2 Hot Cue 2 type deck A min max 0 0 midi range 5 1 |
| Chrissy Kynard 14.04.2013 | This gave me correct results on my APC40: Hot Cue 2 Type> Deck A>Controller Range: Min=-1, Max=-1>Midi Range: Min=5, Max=1. I assume you are using Send Monitor States with this as well (presuming you are using it in Smart Mode)? Otherwise, the color will not retain after pressing. |
<< Back to Post and find Controller MappingsReply