Led output mapping according to encoder position
Led output mapping according to encoder position Posted on: 20.08.2013 by Claudette Darnell I have mapped my Xone K2 as a 4 channel mixer for Traktor and uses the top four encoders as filter knobs. Is it possible to map the LED's beneath the encoders so it that a filter value of 0%=LED OFF and anything else than 0%=LED ON to indicate if any filter is applied to the corresponding deck. | |
| Claudette Darnell 20.08.2013 | I have mapped my Xone K2 as a 4 channel mixer for Traktor and uses the top four encoders as filter knobs. Is it possible to map the LED's beneath the encoders so it that a filter value of 0%=LED OFF and anything else than 0%=LED ON to indicate if any filter is applied to the corresponding deck. |
| Kellie Myrum 20.08.2013 | Nice Welcome dude. |
| Claudette Darnell 20.08.2013 | Works perfect, thanks |
| Kellie Myrum 20.08.2013 | Ahhh, sorry... Use Filter adjust command instead of Filter On |
| Claudette Darnell 20.08.2013 | No matter what I type as controller range i.e. 0.5 it automatically reverts to min=0 and max=1 |
| Kellie Myrum 20.08.2013 | Add out > Mixer > Filter On controller range min=0.5 max=0.5 try both invert check and uncheck |
<< Back to Post and find Controller MappingsReply