was able to fit Pio DJM800 Rotary into DJM900 question :)
was able to fit Pio DJM800 Rotary into DJM900 question :) Posted on: 02.02.2012 by Alfredo Tooher Hey guys I have a quick question for any guys here that are tech guys and may know "volume controls"... The DJM800 has a rotary kit which I own, The DJM900 does not offer it unfortunately yet I was able to get the wiring done properly so I can use the rotary knob in place of the upfader on the 900, My question is, Could this cause future damage or if it works, it works? I want to go all out on the mod and fully install the rotary but am afraid it may cause future issues, not sure if a volume control type is irrelevant in mixers or stereos, Thank you | |
| Alfredo Tooher 02.02.2012 | Hey guys I have a quick question for any guys here that are tech guys and may know "volume controls"... The DJM800 has a rotary kit which I own, The DJM900 does not offer it unfortunately yet I was able to get the wiring done properly so I can use the rotary knob in place of the upfader on the 900, My question is, Could this cause future damage or if it works, it works? I want to go all out on the mod and fully install the rotary but am afraid it may cause future issues, not sure if a volume control type is irrelevant in mixers or stereos, Thank you |
| Alfredo Tooher 05.02.2012 | wow, no one really has an answer to this huh, Oh well |
| Alfredo Tooher 02.02.2012 | I did measure the resistance between the 800 faders and 900 fader and they are VERY close, 8000 (full ON) - 2000 (OFF) on the 900 fader 13000 (full ON) - 2000 (OFF) - on the 800 Again, just not sure if that little of full on resistance can damage anything in the mixer |
<< Back to Reviews of DJ equipment Reply