Two ASIO Devices confilicting? MC 3000 + Xone K2
Two ASIO Devices confilicting? MC 3000 + Xone K2 Posted on: 31.08.2013 by Lesli Parady Hi Folks, first of all thanks for trying to help me out - this is my problem: I have recently acquired a new Xone K2 and it does not seem to get along with my MC 3000 as far as output routing goes. When I connect both devices and start Traktor the Denon Asio Driver doesn't make a sound (yes I have checked the outputs and speakers in Traktor but not even the monitors/ headphones work). Anyways as soon as I change it to the "MC 3000 Shared Mode" it starts working, but of course this is not what i want since it as a bad latency. I have tried to set it up and connect the Xone:K2 afterwards and it always works until the point where Traktor recognizes the device and it completely distorts all audio. It's hard to explain therefore I caught it on video: If you have any advice please help me! Regards, Joseph. | |
| Lesli Parady 31.08.2013 | Hi Folks, first of all thanks for trying to help me out - this is my problem: I have recently acquired a new Xone K2 and it does not seem to get along with my MC 3000 as far as output routing goes. When I connect both devices and start Traktor the Denon Asio Driver doesn't make a sound (yes I have checked the outputs and speakers in Traktor but not even the monitors/ headphones work). Anyways as soon as I change it to the "MC 3000 Shared Mode" it starts working, but of course this is not what i want since it as a bad latency. I have tried to set it up and connect the Xone:K2 afterwards and it always works until the point where Traktor recognizes the device and it completely distorts all audio. It's hard to explain therefore I caught it on video: If you have any advice please help me! Regards, Joseph. |
| Kellie Myrum 01.09.2013 | You tried to adjust latency after the distortion appears? |
| Lesli Parady 01.09.2013 | ------------ PROBLEM SOLVE ----------------------- Just don't use the same USB-Port (No USB-Hubs!)! |
<< Back to General DiscussionReply