Reply to Deck Copy Autoplay Map, Traktor Pro, VCI-100 - (And Poll)

Hey Everyone,
Due to the confusion surrounding deck copy autoplay, I'm starting up this thread. First, a poll: Who here using Traktor Pro, when using deck copy, has their target deck start automatically, synced to the source deck a la T3? Ean says it works for him, I know myself and others who are not getting this behavior automatically. So:
A) Does it work for you or not?
B) What version of TPro are you using?
C) What Firmware version are you using?
D) What operating system?
E) Which tsi?

Since I can't go without this function, I created a set of commands that works around the issue that I want to share with users who have the problem. The key here is that the commands are set up for when you have "load only to stopped deck" checked in prefs. In the example, I am using the navigation cross with the stock labeling, and assuming there are no modifiers in the tsi attached to any of the buttons that will be used. Since many of you are using Ean's tsi, you would need to take into account any modifiers on the cross already, and tweak the directions below so you don't get conflicts (watch out for loop shortening, regular navigation, etc).

Choose a new modifier that isn't being used yet (a new number - I'll use 7 as an example)

1. Add the modifier#7 command, set it to M7=0, value=1, set it as "hold", midi learn the preview/copy button.
2. Add duplicate deck A command, assign to B, add M7=1 modifier, set to trigger, midi learn whatever button you want to use.
3. Add deck focus select command, add M7=1 modifier. Midi learn the same button as in #2, assign to deck B.
4. Add play/pause command, Midi learn the same button as in #2. Add M7=1 modifier. Assign to deck B, set to direct, value=off.
5. Add another play/pause command, midi learn the preview/copy button. Add M7=0 modifier. Assign to "focus", set to direct, value=on.
6. Add a "sync" command (not phase sync), midi learn the preview/copy button again. Add modifier M7=0. Assign to "focus", set to hold.
7. Make sure "Load only in stopped deck" is checked in prefs.

Rinse and repeat for the other decks. Not the preview/copy button, but the others you want to add.

OK, now hold the preview/copy button down. While holding, press the button that you set to copy to. Release both and press the preview/copy button again quickly to start in sync. These commands work perfectly for me. Let me know how it goes, and if you are still having troubles, post your response!