Where are my Faders?
Where are my Faders? Posted on: 16.10.2010 by Penny Chik Hey all,My Traktor randomly restarted fresh and I had to upload the mappings again. After I imported the tsi 3-5-2, everything went smoothly except for the fact that my volume faders and main fader do not show up at all. Any ideas? | |
| Penny Chik 16.10.2010 | Hey all, My Traktor randomly restarted fresh and I had to upload the mappings again. After I imported the tsi 3-5-2, everything went smoothly except for the fact that my volume faders and main fader do not show up at all. Any ideas? |
| Penny Chik 17.10.2010 | Yes! It worked! Thank you so much!! |
| Leeanna Ayla 17.10.2010 | Okay the only way I can duplicate this is with mixing mode set to external in output routing in the preference pane and the layout set to 2D Int. Mixer in the layout upper right corner. With that setting I get slots but no faders. Change the mixing mode to internal and your faders should show back up. |
| Leeanna Ayla 17.10.2010 | Check your layouts. It's happened to me a few times and it took a bit to find the actual reason the first couple of times, but it's there. |
| Penny Chik 17.10.2010 | No, when it is set to internal mixer there are no faders visible on the program. There are the slots where you would slide, but no fader. |
| Leeanna Ayla 16.10.2010 | You probably have it set to external mixer in the preference pane. |
<< Back to Post and find Controller MappingsReply