Problem mapping Kontrol X1
Problem mapping Kontrol X1 Posted on: 19.11.2010 by Faustino Wang I have been trying to map my new X1 in midi mode, however I am running into a few difficulties. For the most part it works, however, when I switch into MIDI mode serveral LED's do not illuminate at all and when I try to map them with the "learn" command, no midi value shows up as if I didn't hit a button. Any ideas? Thanks in advance | |
| Faustino Wang 19.11.2010 | I have been trying to map my new X1 in midi mode, however I am running into a few difficulties. For the most part it works, however, when I switch into MIDI mode serveral LED's do not illuminate at all and when I try to map them with the "learn" command, no midi value shows up as if I didn't hit a button. Any ideas? Thanks in advance |
| Justin Annicchiarico 21.11.2010 | |
| Faustino Wang 21.11.2010 | yep ^^ That was it, can't believe I didn't check that first :eek: |
| Justin Annicchiarico 19.11.2010 | Check the x1 in the Controller Editor software... maybe some button are turned off by default... |
| Faustino Wang 19.11.2010 | ok, I didn't quite explain myself in the best way. The lights aren't an issue, its that the buttons that don't light up in midi mode are unresponsive and I can't map them to any command. In the Transport section its the "In" "BEAT >" 'CUE|REL' and 'SYNC' |
| Latoria Kavulich 19.11.2010 | In midi mode you will need to know the cc values of each led to map them out mate. |
| Annalisa Shogren 19.11.2010 | I'm not sure if the X1 is different as it's an NI product, but don't you have to map the LEDs manually? |
<< Back to Post and find Controller MappingsReply