Reply to APC40 internal 2deck setup
APC40 internal 2deck setup Here is the tsi layout for my apc40 2 deck solo layout. this is for people without an external mixer. it relies on a DUMB MODE APC40 its still a work in progress and i would appreciate anyone's input or modifications. CUE/LOOPS LED's will show two decks. 3x5 grid controls on each deck. controls are read as follows.. start/pause... null... Hotcue1.... nudge... nudge... Sync... Hotcue2... Hotcue3.... Hotcue4.... ------------------------------------------- Activate Loop... Loop size dec.. Loop size inc... EQ/FX FX are toggled with the APC's "activator" and "solo, cue" buttons above channel faders. currently deck A = channel 1 on the APC40, and deck B = channel 3 on the apc. The knobs are assigned to both EQ and FX controls. they are read as follows.. Deck A EQ's... Low / Mid-Low / Mid-High / High FX1 Controls... Wet-Dry / chain fx1 / chain fx2 / chain fx3 FX1 Buttons... On-Off / fx1 on / fx2 on / fx3 on Deck B EQ's... Low / Mid-Low / Mid-High / High FX2 Controls... Wet-Dry / param1 / param2 / param3 FX2 Buttons... On-Off / *null / button2 / button3 *To change effects on FX2, hold null or "device on/off" on your apc40 and turn the effects wet/dry knob FX2 reset was not bound to its button because the LED's on the apc's knobs will not update without being manually moved, preventing any memory of past settings. as a result i had set in traktor to reset the effects whenever they are changed. NAVI Up and Down on the APC40's cursor will move through your playlist. holding shift on your apc will scroll faster. holding "tap tempo" and clicking Left of Right on the APC cursor will load a track into either A or B respectively Please Give Feedback | |
You need to login in order to write on our forum |
<< Cancel