Smart knob mappings?
Smart knob mappings? Posted on: 31.01.2010 by Mac Fly Just recently geting into midi mapping and smart knobs. I was wondering if any of you guys know of any good smart knob combos? | |
| Alec Reback 05.01.2011 |
Originally Posted by makio001
|
| Mac Fly 31.01.2010 | Just recently geting into midi mapping and smart knobs. I was wondering if any of you guys know of any good smart knob combos? |
| Charline Dye 06.01.2011 | click the youtube link in my sig. I have a couple of things you might like. A reverse knob and a couple of super buttons. Also on my channel is a link to ArmyofMe's superknob sweep which is very good. The Freeze is done with a button. If you want to you can map a knob as a button so when you turn it from zero it turns on and off again when turned back to zero. A combo of delay knob for dry/wet and amount and a button for freeze is what I use and what Ean did it on his Oxygen mapping. I don't believe you can map a knob/fader to turn on a button at the middle or end of it's travel without Bomes. Only the beginning. The VCI firmware and the new Midi fighter firmware give you Midi notes to map in the middle and end of the knob/fader range, but that is on the hardware side of things. Ean came up with this for his Fader Fx Theory. |
| Alec Reback 05.01.2011 |
Originally Posted by makio001
|
| Allene Manitta 23.02.2010 | one way is the midi-message send by the EQ-knobs of the vci 100, when turned to 50, or the kill message on these when turned to 0 |
| Romeo Peede 22.02.2010 | how do you have it freeze at a certain midi value? i haven't seen a feature in traktors midi mappings for that... but i've seen some videos of ean where it is done.. |
| Hipolito Scionti 01.02.2010 | Well it's obvious and basic but a delay knob that controls the dry / wet and amount and it turning on and then freezing at a certain point is very useful... |
<< Back to Post and find Controller MappingsReply