Reply to Mapping devices with the APC40

Hi there

I use my APC40 with ableton. Out of the box the device controller region/knobbly bits control the device assigned to whichever audio track is highlighted. However, when I try to change the mapping manually it loses this ability.

So for example the EQ3 will control whichever audio is prioritised but the selection of knobs is not quite how I like. So I map it as I wish but then it will only control the audio track device which was prioritised when I mapped, so when I adjust the eqs it doesn't change anything on the track I'm interested in.

Only work around is to set them on later banks, but I try to minimise how many clicks I need to make so isnt ideal.

Is there a way to re-map to the device that is prioritised.

Hope that makes sense.

Thanks

G