Reply to Simple LED question re: Beat Jump on APC40

So, this is what I would like:

Button 1
Beat Jump -4
not active= no led
on push= orange

Button 2
Beat Jump +4
not active= no led
on push= orange

but when i program this Button 1 works fine BUT once I program button 2 they seem to interact with one another. For example, if I push button 2 then button 1 lights up orange. If I push button 1 then button 2 lights up orange.

If I remove the Beat Jump OUT settings for the LED then both operate as expected in green instead of orange.

Ideas?