Reply to VCI-100 for Traktor Pro (user modified SE)

Changelog:
v3:
- improved browser-mode: You can now load the selected track by moving the outer jog-wheel backwords to load it into deck A or forward to load it into deck B
this will also quit the browser-mode (thanks to Bento for the suggestion)
v2:
- new browser-mode: lets you browse through your filelist with the jog wheel, while it is active
- updated transport-section: it basically works like the official settings from Vestax for the VCI-100
- floating cue-point : whenever you move the jog-wheel a temporary cue-point is set (like in Traktor 3)
- loops will reset to a length of 4 beats after you turn them off (thanks to ean)
- Loop & Key are swapped

A lot of features are planned, but I'm currently short on time due to exams in the coming weeks. To see which, check out the attached image.Please comment them and drop ideas in this thread.

This is based on the official DjTechTools-VCI-file from the other thread.
I used burndownthediscos VCI for the FX unit toggle.
It also fixes the bug where deck A is stopped while using the jog-wheel in Fader-FX-mode.

Personally I find the whole fx-stuff too complicated in Ean's layout.
Therefore I tossed the 1st effect (only 2 per FX bank are useable but because of the FX unit toogle 4 effects can be used per deck which should be enough).
And mapped it so you can browse through all the shiny new effects, instead of being forced to use only a few ones.

Effects turn automatically on when the knob is turned to the right side and in most cases their LED lights up (some don't work because of firmware issues).

I made this with FW 1.2.