mapping question

Home :: Post and find Controller Mappings :: mapping questionReply
mapping question
Posted on: 24.01.2012 by Sam Hanno
maybe i'm a fool, but I can't figure out which command equates to cue 1,2,3 etc. I see how to set and store a cue point, and how to cycle through saved cue points, but not how to set buttons so that cue point 1 is one button, 2 is another, etc.
Help?
Chasidy Heckenbach
26.01.2012
Originally Posted by paw_20
maybe i'm a fool, but I can't figure out which command equates to cue 1,2,3 etc. I see how to set and store a cue point, and how to cycle through saved cue points, but not how to set buttons so that cue point 1 is one button, 2 is another, etc.
Help?
add an IN of "select_set_store_hotcue" and then select deck "a" and cuepoint "1" in button mode if thats the one u want to assign - rinse and repeat
Sam Hanno
24.01.2012		maybe i'm a fool, but I can't figure out which command equates to cue 1,2,3 etc. I see how to set and store a cue point, and how to cycle through saved cue points, but not how to set buttons so that cue point 1 is one button, 2 is another, etc.
Help?
Chasidy Heckenbach
26.01.2012
Originally Posted by paw_20
maybe i'm a fool, but I can't figure out which command equates to cue 1,2,3 etc. I see how to set and store a cue point, and how to cycle through saved cue points, but not how to set buttons so that cue point 1 is one button, 2 is another, etc.
Help?
add an IN of "select_set_store_hotcue" and then select deck "a" and cuepoint "1" in button mode if thats the one u want to assign - rinse and repeat

<< Back to Post and find Controller MappingsReply

Copyright 2012-2023
DJRANKINGS.ORG n.g.o.
Chuo-ku, Osaka, Japan

Created by Ajaxel CMS

Terms & Privacy