Reply to Xone 4d Mapping Help needed

Hi there I have recently got the xone 4d and I am struggling too create my perfect layout.



My vision is too have 4 modifiers for example m1=1 m2=2 m3=3 m4=4

Each modifier would be mapped to a Light Pipe L.E.D.

I can get this to work by using the modifiers one is set to m1=0 one set to m1=1 with direct button values set to 1 and 0 (and then values of (0,2) (0,3) (0,4))


What I would like to make is a mapping that seamlessly switch between layers so I dont have to turn off modifier 1 before I activate modifier 2

If I could figure out how to do this I would be able too complete my traktor mapping which I would like too upload too share with everyone here at DJTT

Thanks for reading any Input is greatly appreciated