Reply to X1 LED for Hotcue State 1

Hey everyone,

So I recently picked up an X1 and am working on mapping it for what I need. I am essentially done, but I have one problem. I mapped the 16 buttons at the bottom to cue points for deck A (left 8 buttons) and deck B (right 8 buttons), but when I load a track the LED for cue 1 won't light up (mapped to the IN button). I found out, thanks to my roommate, that the reason it doesn't light up is because the first cue tends to be a grid type, and thus my mapping for output of Hotcue 1 state doesn't apply. I have the buttons mapped exactly like I mapped it on my APC40 and I never had this problem. Is there a fix for this? I didn't see any Grid cue 1 state or something that I could map to output the LED for a grid cue point.

In case this helps, the three things I have mapped to each button in this area are
1) Set/store Hotcue - Button - Hold - Deck A - Hotcue 1
2) Send Monitor state - Button - Trigger - Global - Invert
3) Hotcue 1 state - LED - Output - Deck A - Controller Range(0, 1) - Midi Range(0, 127)

TL;DR - LED for Cue 1 won't light up since it is often a grid cue point.