Mapping the Active button in Traktor/ Automatic loop points for mix out.
Home :: Post and find Controller Mappings :: Mapping the Active button in Traktor/ Automatic loop points for mix out.Reply
Mapping the Active button in Traktor/ Automatic loop points for mix out. Posted on: 03.02.2013 by Shila Ioffe Hi guys this is my first post so sorry if this is a silly question.I use Traktor with Maschine and the template that comes with it with some modifications. . When Im playing a song in one of the decks and then press the active button with the mouse it will play until it hits the next stored loop points and then start looping (mix out Loop). How do i map this? I tried mapping Deck Common/Loop/Loop Active On, but when i press it on Maschine it starts looping wherever the song is up to. I basically want all my song to automatically loop at there mix out points. Any suggestions would be much appreciated. Thanks for reading. | |
| Shila Ioffe 03.02.2013 | Hi guys this is my first post so sorry if this is a silly question. I use Traktor with Maschine and the template that comes with it with some modifications. . When Im playing a song in one of the decks and then press the active button with the mouse it will play until it hits the next stored loop points and then start looping (mix out Loop). How do i map this? I tried mapping Deck Common/Loop/Loop Active On, but when i press it on Maschine it starts looping wherever the song is up to. I basically want all my song to automatically loop at there mix out points. Any suggestions would be much appreciated. Thanks for reading. |
| Kellie Myrum 04.02.2013 | You make sure to set ACTIVE ON and not LOOP SET? Works fine for me. |
| Shila Ioffe 04.02.2013 | Thanks for your replay Stewe, I can use the hot cues but when i press the hot cue where my mix out loop is stored it will jump to it immediately. I'm looking for a way to activate the mix out loop points automatically when it is reached so I can spend my time cueing up the next track and not worry about the playing track running out. |
| Kellie Myrum 04.02.2013 | Isn't that when hot loop is stored it will automatically be activated once the loop is reached by needle position? Somebody correct me if I'm wrong but there's no need for any mappings it this case. |
<< Back to Post and find Controller MappingsReply