Reply to Vestax VCI-100 Single Button Brake Effect Not Working Properly and Pitch Range Button

Hi, I am hoping someone can help me with the following 2 issues.

Issue # 1

I recently purchased a Vestax VCI-100 (Silver) and updated to FW 1.4. I am currently creating my own custom mapping and have set up a Single Button Brake Effect. The effect is not working properly. When the button assigned as the Brake Button is pressed, the braking effect does not happen until about 4 seconds later. Why is there a delay of about 4 seconds before the brake effect engages? I want the brake effect to engage immediately. I imagine my mapping is incorrect and I am hoping someone can help me fix this issue.

Here is a snapshot/attachment of Xtreme Mapping App showing my mapping of the effect.

Screen Shot 2013-06-11 at 10.48.37 PM.jpg


Here are the values that were set.
Wet/Dry value = 1 (Full)
AMNT value = 0
R.SPD value = 0
B.SPD value = 0.630

Please show me how this can be resolved.

Issue # 2

I would like to know how I can make a single button on my controller change (Toggle) the Tempo Range from 12% to 20%. I know I can manually change the setting under Transport Tab - Tempo Range Selection with a mouse but I want to be able to make this change using the controller.

Please keep in mind, that I am very new to the world of Midi Mapping so if my question is pretty basic stuff then I apologize in advance. I have done some research on the internet and looked through this community but I am stuck and frustrated. I would really appreciate some guidance.

Thanks,
Dan B.