Reply to VCI-100 for Traktor 3 (page swapping master fx)

So after a while i finally got my tks how i want it...

Stealing the 3 pots from Master Level, Monitor Level, Monitor Select and translated them to controls for midi page swapping. Heres how it works:

To be on page 1, all three of the knobs have to be cranked left all the way.

To access and hold page 2, turn the old Master Level knob to the right. It doesn't have to go all the way to the right, it just needs to be off of the 0 mark enough for it to engage. The Monitor Level and Monitor Select knobs have to remain at 0 - full left - in order for it to work.

You must turn all three of the knobs to full left (re-access page 1) in order to access another page.

To access and hold page 3, turn the old Monitor Level to the right in a similar fashion. Meaning, keep the Master Level knob and Monitor Select knob at 0.

To access and hold page 4, turn the old Monitor Select knob to the right, while keeping the other two full left.

Sounds strange now that I'm typing it, but once you get used to it, the changes arent that weird. I advice that you make a small white mark on each of the knobs since they are small and hard to tell which way they are turned at times.

Anyways, now that you can switch pages... What do they do???

Page 1 -Everything stays the completely normal VCI Controls.

Page 2 -FX on jog wheels and volume faders (works amazing with beatmasher). Volume gets transfered to the tempo faders. and tempo gets thrown onto EQ hi (I figure that i wouldnt be using that knob much at all when I was using this page. Plus, the EQ hi has a similar setup to the tempo fader, since it has that middle lock position). All other controls stay stock.

Page 3 -6 cue Points on each deck. Play/pause, Cue/play, cue/pause, set cue, taping the center of the jog wheel, and then spinning the edge of the jog wheel (mainly used as a finally cue point when done beat juggling and want to jump back to a specific part of the song). Since in order for the cues to actually play instead of just switch to that position in the song, the song has to be playing in the first place. So just incase I load the track while in Page 3, I set the Sync button on each deck to Play/Pause.

Page 4 - All controls the same except set up for Decks C and D.

I havent gotten to use this final set up too much, so I'll probably still be making some minor tweaks, but I'm pretty happy with it so far. One thing that sucks is that I cant figure out how to allow all the Page 2 and 3 settings for decks C and D... I probably need to learn how to use midipipe or something, but meh.

I'm just starting out, so comments anyone?

Here goes nothing...

http://www.mediafire.com/?v7ynz1n2zdd