Reply to X-Session Pro - swap knobs to get centre notch on all channels?

Hi,

Does anyone know if it is possible to swap the knobs around on the X-Session Pro? I use mine for four channels (with volume and EQ on each) and I'd really like to have a center notch on the bottom knob of each channel (so I can easily drop the bass back in to 0db), so I was hoping I might be able to swap the middle two 'mid' EQ knobs (where the notch isn't so important) with the outer two 'bass' EQ knobs.

Is this possible? Is the notch in the top "knob" part of the knob (which I should be able to remove easily), or is it in the actual shaft assembly bit (as shown in http://www.djranking s.com/community /att...8&d=1216646662 - I guess this would be pretty difficult to do if that is the case as it'd require soldering etc.)?

I'll give it a go removing the top parts of the knobs toevening if no one knows... I'm not so desperate to do it that I'm going to get the soldering iron out though

Cheers,
Tom