Reply to Custom VCI-100 (Editable) Overlay File: Illustrator

I am excited that I will be soon getting a VCI-100. I want to customize mine including the plates but I wanted the layout to match DJ TechTools custom TSI for v3 so I searched high and low for a overlay and I finally stumbled upon a file from Native Instruments community of a VCI-100 basic overlay but had no editable features. I just spent about 3 hours remaking one from scratch including some parts of that old file that I found.

Font is a custom font I liked but anyone can add or remove what they like. Below is a .png tell me if you like it and Ill upload the illustrator file.

Im either planning to have a friend vinyl cut this or i was believeing about using my clear sticky paper and applying on the plates, then use xacto knife to make the holes. Then if a new tsi comes out i just peel and change what i want later on.

P.S. If you dont have Adobe Illustrator and would like a custom .png give me a pm or post.
Thanks

[UPDATE]
Added .pdf as the .png wasn't going full size for some reason.