Reply to Filter-Configuration in Traktor 3

Hi

I'm trying to find out, which way the Filter on the VCI100SE is configured in MIDI Settings of Traktor. There is a Lowpass-Filter by turning the Knob to the left and a Highpass-Filter by turning it to the right.

Is it correct, that the Filter:T2 is controlled that way? To get both Filters on one Knob, at least two "Software-Knobs" of the Filter are turned, right? I've tried to configure it the same way on my Ecler Nuo 4, but I didn't get the same result. Which way can make a LPF on the left, no Filter in the middle and HPF on the right? It's very tricky... I also read the TKS files of the VCI100, but I did not find it out without knowlegde about the knobs and their signals

greets from Germany