Reply to Hardware related problem, broken USB connection
Hardware related problem, broken USB connection Hello out there DJ TT Forum... I've recently purchased my vci100 and upgraded the firmware/exterior, etc etc. In an act of carelessness in transit, my 4-pin USB connection on the rear panel was bent, and now I am worried has separated contact with the main controller board. After a brief flutter of going off and on/connectivity issues, it will no longer power on. To my dismay upon opening the USB seeding portion has been pushed to an angle (see attached photo). I'm wondering if anyone out there has had to do any hardware surgery like this before? I am not experienced in the way of soldering and this type of replacement; I am believeing to just take it to a local computer repair shop? Any help/information would be greatly appreciated, | |
You need to login in order to write on our forum |
<< Cancel