Reply to Vci-100+ Fw 1.3 pitch fader question
Vci-100+ Fw 1.3 pitch fader question this is a Theo's thread , but I have a exactly same problem with him, please help us, ean!! Greetings to everybody, I am a relatively new owner of a vci-100se and i just downloaded the new mappings. I have two problems that might seem stupid or naive to many of you (after some searching i did to the community i couldn't find what i was looking for). I am sorry in advance if this problem/question is already answered somewhere else in the community , if someone knows please point it out. 1. Software Pitch fader range is -+100% - while the VCI-100 knob takes it to -+8 to it's min-max. Even if I change the settings for the software pitch fader range and choose -+8 or -+10, I now can move -+0.5 or something, meaning I only control less than one tenth of the full range of the pitch fader with the VCI knob. Since I am interested in fine pitch adjustments and I am not interested in a +100 pitch change, how could I make the knob of the VCI correspond to the full range of the software pitch? 2. Track strip (don't know if i'm using the right term). When I load a track on any player, I cannot see the complete track waveform, but only the minute marks. I read in the manual I have to wait for the tracks to get analyzed (or smthg like that) but no matter how much i wait, the track strip still remains empty. This happens to 99.5% of my tracks (for some reason I randomly discovered a couple of tracks that were actually displayed but for all the rest it's the same problem). Thank you in advance for any help/insight! Theo's set up XPS M1330 - Vista SP2 - Traktor Pro 1.1.2 - VCI-100SE - TSI 2.3 my sey up Macbook Black + osx Leopard + traktor pro 1.1.1 + vci-100 + Fw 1.3 + Tsi 2.3 | |
You need to login in order to write on our forum |
<< Cancel