Reply to Upgrade Issue !
Upgrade Issue ! Hi everybody ! I have tried to upgrade my VCI 100 1.1. AND... I have the 15024 Error number : Boot failed. - 1 So, First when I make the workflow I put the VCI in boot mode. BUT, There are no lights on. Is this step good or Should it be flush? - 2 After, I launch my upgrade with a usb/serial cable on an opened Com (COM 5 for example). And I have the error (see above). So I have tried to unplugg the firmware from the VCI, and to unplugg the firmware kit and to lauch the soft with just the usb/serial cable : And I have the same error ! So I don't know where does come from this issue... Could you try with your cable alone to compare results? I am lost ... Thanks ! | |
You need to login in order to write on our forum |
<< Cancel