Reply to play/pause acting up

win xp
traktor pro 1.2.1
firmware 1.3

i made a 4 deck map and My A/C deck Play pause is acting up. I have to hit it 2 times to turn it on or off, it kinda sucks.

B\D play pause works fine and the buttons are all configured the same.

any ideas, suggestions?

*EDIT*
i have noticed that when i switch to 1.2 the play/pause works as it should.

but then i have the same all the 1.2 problems.


**EDIT**

i believe i figured it out

Version 1.3
* You can tell if you have 1.3 by following these steps.

1) connect your vci-100 to a computer but dont start traktor.

2) Click the button that is at the top right hand corner of the left jog wheel (its next to the filter knob for deck A).

3) If this button toggles on and off then you have 1.3 (the same button on the right side will not toggle on and off.

this is the same button Iamhaving trouble with. and I believe this is the reason.

...i believe.