Reply to CONSTANT crashing when using FX banks/slicer w/ VCI-100SE & 1.4

** Just as a quick note, my original re-mapping of my original VCI-100 (1.1 or 1.2 don't remember) always worked, never crashed, no glitches, nothing **

My comp is a 2.8 GHZ, 4GB ram, etc.. its a power desktop I built myself so I'm not worried about specs, ram or memory.

OK, so I read the readme's, I've tried both the MAC and PC (1.4) mappings, both are fine EXCEPT when I want to do a lot of FX, I'll load up FX bank 3 or 4 (gater + whatever or beatm + whatever), use that, use the volume faders, pitch sliders, jog wheel etc... then, once in about ten or twenty times or so, the entire Traktor program will lock up and the sound output will be a 1/8 clip looped and extremely loud, like a huge glitch glitch glitch.

If I restart my VCI right away (off, then back on), Traktor will delay for 1-2 seconds but continue playing the song without the FX and go back to normal. Then I'll have to go BACK into Controller Manager and reset the mappings to the midi device.

Also, use the FX router gives off glitchy noises with both mappings for me (so does holding the SHIFT button sometimes), all of this is really annoying and frankly makes me wish I could go back to what I had previously before opening the entire thing and upgrading the firmware.

Is there any solution to this? I have to play a show tomorrow evening !

Thank you!